1. If the burned area of ​​the cylinder mat is small, use an asbestos thread to fill in. If the burned area is large, you can cut a piece of shimming from the same part of the waste cylinder mat with the same thickness and gently tap it to make the joint well. If the burnout is between two cylinders, the asbestos thread should be wrapped with copper skin.
2. Radiator breaks in and out of the water hose If there is any breakage, use a piece of cloth to coat the leaked area with soap, and then use a wire to tie it tightly. If the breakage is severe, cut it into two pieces with a knife from the broken part of the hose. Bamboo tubes, etc., are placed between the hoses, and then tied with iron wire, and then can be loaded; when the radiator core copper tube has slight leakage, soap can be used to stick the leakage. If the water leakage is serious, use the orange light clip to leak water so that it does not leak water.
3. If the valve spring breaks only one break, the two break springs can be installed and used. If the spring is broken at several places, the multi-cylinder machine can remove the adjusting bolts of the inlet and exhaust valves of the cylinder and close the valve. The cylinder stopped working and cut off the oil.
4. Sudden power cut in the middle When the horn does not ring suddenly, the lights are completely off, the starter does not turn, etc., it means that the vehicle is completely off. At this time, you can first check whether the pile head of the battery is loose. Do not squash when inspecting. Use a pair of pliers to test the two pile heads. If there is no spark, then the pile head is loose and tighten with a wrench. If the pile head is tightened and cleaned, the power-off phenomenon remains. If it is not eliminated, check the connection of the two-pole wires, such as poor contact, repair in time; if the battery has a single-cell damage, use the copper wire to directly connect the good cells.
5. Clutch slip If the friction plate is stained with oil, you can step on the clutch pedal, use the oil gun to install gasoline, aim at the gap between the flywheel, friction plate, and clutch pressure plate, so that the above oil can be dissolved temporarily. (If there is no oil gun and substitutes, you can use plastic pipe or rubber hose to suck the oil and aim it at the shot); if the friction plate slips due to burning, it will be able to burn the damaged part, but it should be started steadily when driving, and the speed change action Be quick.
6. Leaf Spring Breakage According to the situation, wood blocks are placed between the leaf spring, the axle and the frame, and temporarily tied with iron wire, etc., and they are driven to the repair point for replacement.
7. No jacks change the tires and replace the double-row tires. Use wooden blocks or bricks and bricks to lift the inner wheels. The outer wheels can be hung and can be replaced. When the front wheels or single tires are replaced, wooden blocks or bricks can be used. The front axle or rear axle of the stone will be stable, digging above the tire to be dismantled, so that the tire can be vacant, and can be removed and replaced; the inclined roof of a flat top wood is used under the front axle or the rear axle of the tire to be changed, and then operated. The automobile makes the top wood lift the front axle or the rear axle. When the top wood is vertically stabilized, the tire can be replaced.
8. Blown fan tape Damaged fan tape, mostly broken. Several ropes can be used to fasten the strands. The length and thickness should be similar to those of the original fan tape, but the rope should be flashed in the middle and cannot be exposed, and then tightly tied with iron wire; the original fan tape can be broken at each end of the drill. Holes, temporarily connected with coarse wire. However, the law should test the engine for a few minutes to check if the fan rotation is normal.