Cycad bonsai rapid production method

Cycad, also known as Tieshu, is a fine material for the art of flower arranging with its thick green pinnate leaves. The bonsai is produced with its small plants. The ornamental effect is better and it is loved by bonsai enthusiasts. Although there are three kinds of cycad fertilization methods: seeding method, parturition method, and stem cutting method, the family pot is best suited for the tiller method. It is simple and convenient, and has a high survival rate. The specific practices are described below for reference. First, the time of early May. Second, the bottom of the insertion bed is 5cm thick river sand (if it is exposed bed should be thickened), the upper layer is 1/3 river sand and 2/3 humus mixed soil, about 15 cm thick. After being paved, it is thoroughly impregnated with 3‰ potassium permanganate solution and tightly sealed with a plastic film. It can be used after 1-2 days. Third, the method of choice for delivery on a cloudy day. 1. The roots of the axillary buds to be cut are cut off so that the buds will not excessively transpiration after cutting off the mother's body, and it is also convenient to operate. 2, with a knife or saw the axillary buds removed from the mother, the incision should be as small as possible, with air rooting is kept as much as possible, but the air root is too long to be cut short. 3, will cut off the axillary buds on the incision painted grass ash, to prevent the flow of fat, and then placed in a cool, ventilated place, time 3-5 days. 4. Soak the dried axillary buds with 3‰ potassium permanganate solution for about 10 minutes to fully sterilize and prevent mildew. Then, pry open and insert the axillary buds, not too deep, but you must cover the incisions. Fourth, after the management is plugged in, no watering is required. It is necessary to take a plastic arch shed in time to prevent rain, otherwise the shoots will perish and the leaves will not be able to grow. At the same time appropriate shade, and prevent man-made collisions. After 1 month, the buds will have 1 to several rounds of neat, green new leaves and begin to root. After the root system is prosperous (about 3 months later), you can pour the faint bran water and fertilizer, but the number should not be too much. At this time, the shed can be removed and allowed to grow naturally. Finally, accompanied by a flower pot wooden frame, a celery bonsai that made indoor brilliance was successfully produced.

Other Tattoo Ink

Best Black Tattoo Ink,Stable Tattoo Inks,Classic Tattoo Ink

Kiay Trade Cosmetology Co., Ltd. , http://www.chinatattoomachines.com